#Audacity won't record second track software

In Selection Toolbar make sure that ' Snap To' is set to 'Off'. But in the end you should settle on a value for both Audio to Buffer and Latency Correction and leave them there. If you are feeling adventurous you can repeat this test with different values for Audio to Buffer. Too low a value may put too much load on the CPU causing dropouts in the recording. 100 milliseconds is a safe value that will not put too much load on the CPU. The Audio to Buffer amount will affect latency, but the effect will vary between systems.

#Audacity won't record second track software

Instead you need to set up the microphone in front of a speaker or headphones! Don't worry, you won't get feedback because you've turned Software Playthrough and Hardware Playthrough off. If you are using a microphone to record overdubs then the loop-back cable method will not work for you. Depending on your interface you may need a different type of loop-back cable.Įxample of loopback with a USB audio adapter If you are not using the line input and/or line output ports on your computer but are instead using a USB audio interface device for input and/or output, plug the loop-back cable into the appropriate jacks on the USB interface. If you are connecting your recording equipment to the line input and line output jacks on your computer you need a cable with a stereo mini-plug at each end. The type of cable you need will depend on the way you are connecting your recording equipment to the computer.Ĭonnecting to the line input and line output ports on the computer

To do a latency test you will need a loop-back cable.